Krystal Model Tray System |
Simple
to use but, above all, Accurate! |
|
|
|
Remove a Krystal tray from the
dispenser . Trim the impression in
the normal way . Replace the white tongue with an orange casting
tongue (supplied). Retain the white tongue for use after sectioning. |
Spray the inside of the Krystal Tray and all
surfaces of the Orange Casting Tongue with SnapSlip Model Release Spray. |
Articulation should be carried
out before the sacrificial membrane is removed. |
|
|
|
| Put the shaped end of the SnapFree tool into the slot under the
rear edge of the tongue. |
Replace all sections of the
model back into the Krystal tray, and holding the model and tray securely from above, give
the base of the tray a positive tap on the workbench to ensure that all the sections are
fully re-seated. Replace the white working tongue to retain the die sections securely. |
Krystal Model Trays have been designed to be
used with the Krystal Disposable Articulator using either two trays or |
|
|
|
| one Krystal Tray and a solid model. |
The Krystal Disposable Articulator has snap-off
tabs to fit into the Krystal Tray or, left complete for use with solid models. The
articulator is adjustable for height and gives some lateral excursion. |
The Krystal Disposable Articulator is fixed in
position by use of the special Krystal Articulation Primer, Adhesive and Activator. |
